Ford Fiesta ST Forum banner

Status
Not open for further replies.
61 - 73 of 73 Posts

·
Vendor
Joined
·
1,106 Posts
Discussion Starter #64

·
Vendor
Joined
·
1,106 Posts
Discussion Starter #65
Welcome to the Presidents Day & Valentine’s Day Long weekend!



Winter is winding down and spring is around to corner, time for some carbon wrap!

We have some great deals going on with our 3D Carbon Wrap this weekend

Hexis Carbon Fiber - Woven Texture 3D Structured Vinyl

Carbon Sale ends Monday 2/15/2016 – limited to quantities on hand supply limited don’t miss out!

We are also offering free domestic shipping on all orders over $50 (regularly on $75+ orders)

Free shipping ends at 8PM PT / 11PM ET Monday 2/15/2016

Shipping and USPS will be closed Monday and long weekend orders will begin shipping on Tuesday the 16th in the order received.

Also about two weeks left to enter our Winter 2016 Install Photo Contest!



Details here:

Headlight Armor Photo Contest

We have received some good shots thus far! If you have entered, thanks! If you have not entered yet, let’s get them in – clock is ticking. The deadline for entry in February 29, 2016
 

·
Vendor
Joined
·
1,106 Posts
Discussion Starter #66
Somebody on another forum we support asked about how conformable the wrap material is so I though I would post here as well for those thinking about the carbon wrap:

The material was designed for full vehicle wraps and conforms very well.

There are a lot of photos on the mail rolls product page here:
60 Inch Wide Hexis Carbon Fiber Vinyl Wrap With 3D Texture

including:




You will need a heat gun to finish the install when applying to a heavily contoured surface. Post heating the material will reset the memory of the material.

Hope that helps.
 

·
Vendor
Joined
·
1,106 Posts
Discussion Starter #67
Wrapping up our long weekend sale.

We have some great deals going on with our 3D Carbon Wrap this weekend

http://www.headlightarmor.com/carbon...inyl-wrap.aspx

Carbon Sale ends Monday 2/15/2016 – limited to quantities on hand supply limited don’t miss out!

We are also offering free domestic shipping on all orders over $50 (regularly on $75+ orders)

Free shipping ends at 8PM PT / 11PM ET Monday 2/15/2016
 

·
Vendor
Joined
·
1,106 Posts
Discussion Starter #68
Super close ups of the corner of a wrapped hood:





When wrapping the hood or any area with a rounded corner for that matter, set the middle part of the area and when working the edge set the corners first, then the long edge. This will distribute the material cleanly and leave a clean corner. If you set the long edges first - you know because it seems easier - you wind up with too much material at the corner and nowhere for it to go.

Special pricing on 60" wide rolls:
60 Inch Wide Hexis Carbon Fiber Vinyl Wrap With 3D Texture

Good while supplies last!
 

·
Vendor
Joined
·
1,106 Posts
Discussion Starter #72
Several emails received this week about the wrap.

We are down to a single 60" wide by 60" long roll. If you are looking to wrap your hood measure the max width and depth of the hod and make sure you will have enough material. The material does stretch but ideally your hood should be smaller than the material.

we have a couple of small sheets available too

All grouped on the site here:
Hexis Carbon Fiber - Woven Texture 3D Structured Vinyl
 

·
Vendor
Joined
·
1,106 Posts
Discussion Starter #73
61 - 73 of 73 Posts
Status
Not open for further replies.
Top